Morgardshammer Cross Country􏰊 3-Hi Four Stand Reversing Mill with
(1) P-473a 3-Hi breakdo􏰈wn & (3) P-481a 3-Hi finishing stands, Re:25555

One 564mm (22.2050") x 1􏰋00mm (􏰌0.􏰋660") 3-Hi Roughing Stand/Breakdown Mill
Model P-473􏰌a
Material Entry Size: 203mm (8􏰋") Diameter Billets Max
Material Exit Size: 50.8mm (2") Square/Round Bar
Spherical Roller Bearing Design
Powered Screw Downs
Top/Bottom Roll Adjust (on the fly)
Drive Motor: Mfg., ASEA
Rated Capacity 􏰌􏰍790kW (1,059􏰍hp), 50 – 1200 RPM, 500 Volt DC
Drive Assembly Gear Reducer
Interconnecting Drive Spindles & Couplings
Three Set Up Stands – Roll Chock Assemblies
Roll Inventory including one New and Never-Used set
Material Handling Tilt Table Assemblies

Three 406mm (16”) x 􏰌11mm (2􏰋”) 3-Hi Finishing Stands, Cross Country Drive Arrangement
Model P-4􏰋81a
Material Entry Size: 61mm (2.4") Diameter Bar
Material Exit Size: 10mm (.3􏰍3") square & round bar
Spherical Roller Bearing Design
Drive Motor: Mfg., ASEA
Rated Capacity 􏰌􏰍790kW (1,059􏰍hp), 50 – 1200 RPM, 500 Volt DC
Drive Assembly Gear Reducer
Interconnecting Drive Spindles & Couplings
Two Set Up Stands – Roll Chock Assemblies
Roll Inventory

A large assortment of spare parts for all equipment.

Note: Materials processed by this Mill: U-718, U-901, D-979, A-286, Ni-80, Ni-90, Waspaloy, M-252, X-750, U-625 & UDHX

The Mill has been properly maintained and is in very good condition. It is still installed and available for inspection under power.

Typical Rolling Pass arrangement is available on request for both the 3-Hi Roughing Stand and the 3-Hi Finishing Stands.

Inspection is available by appointment at a New York State plant site.