Dia
|
|
|
|
Type
|
|
|
Manual Open Side Planer
Manual Open Side Planer
|
|
|
Builder
|
|
|
|
Model
|
|
|
|
Age/Rtft
|
|
|
|
Tbl L
|
|
|
|
Tbl W
|
|
|
|
Ref #
|
|
|
|
Taper in Spindle
|
|
|
|
Vertical Head Travel, Y-Axis
|
|
|
|
Column Travel, X-Axis
|
|
|
|
Spindle Travel, Z-Axis
|
|
|
|
Spindle Speeds (quantity)
|
|
|
|
Spindle Speeds range
|
|
|
10 to 130 rpm
10 to 130 rpm
|
|
|
Main Spindle Drive Power
|
|
|
|
Machine length
|
|
|
|
Machine width
|
|
|
|
Machine weight
|
|
|
|
|
|
|
Convert to Inches
Convert to Metric
|
|
Equipped with two (2) Hydraulic Clamping Fixtures as follows:
• Fixtures consists of two complete clamping units, each unit including a housing, clamping rail and supporting brackets. • Adjustable Clamping Rail - adjustable for clamping the various width of die blocks • Housing is manually located on the table in one of the two positions; one position for blocks from 14" to 27" thick, and a second position for blocks 27" to 40" thick • Each fixture is equipped with pendant operated though push buttons and selector switches • Capacity – the fixture is adjustable for holding the following sizes of die blocks: • Thickness – 14" – 40" • Width – 36" – 90" • Length – 58" – 21-1/2 ft. • Electrics – 440 volt, 3 phase, 60 cycle, AC as follows: • (1) 7-1/2" HP AC motor for adjusting crossrail • (1) 5 HP AC motor for driving the hydraulic pump motor • Weight – estimated weight of the fixture and its parts is 140,000 lbs • Magnetic Clamping on each fixture as follows: • Fixture 1 – Sundstrand magnetic Control, 480 v AC - 244 DC • Fixture 2 – Neutrofier II Magnetic Control, 280/400 AC – 244 DC • 72" x 10" Magnetic face on each fixture • Travel: Vertical travel – 64" • Hydraulic Unit: Vickers Note: Maximum recommended evenly distributed weight on table is 740,000 lbs.
If one fixture is used then reduce by 140,000 lbs and if two fixtures are used then reduce by 280,000 lbs. The machine was originally designed to perform general face milling operations on die blocks.
|